25.02.2022

Thermal insulation of pipelines, protection against condensation

Cold water pipes are often covered with condensate, which first becomes the cause of corrosion, and then-the rapid failure of the pipe, the appearance of dampness, as a result of which mold forms on the walls and not a pleasant smell.

To get rid of this problem, it is enough to isolate the pipes from the warm indoor air with the help of Abris materials. Our technologies have been tested and have shown their reliability and durability not only in domestic conditions, but also in industry - in refrigeration units.

Insulation design

Isolation of a rectilinear section of the surface

Sealing of joints

1.Steel surface (ground).

2.Primer.

3.Mastic-polymer anticorrosive layer in the composition of Abris S-LTfiz tape.

4.Thermal insulation layer based on foamed polyethylene (isolone) in the composition of Abris S-LTfiz tape.

5.Aluminium foil in Abris S-LTfiz tape.

6.Mastic-polymer steam, moisture, gas-tight layer in the composition of the tape Abris S-LTm or Abris S-LTf.

7.Metallized film in Abris C-LTm tape or aluminum foil in Abris C-LTf tape.

8.Tape (part) Abris S-LTm or Abris S-LTf.

9.Tape (part) Abris S-LTfiz.

10.Joint of Abris S-LTfiz tape.

Insulation layer

Isolation of curved surface areas

Curved section of pipe

Advantages of the technology:

reliably protects the pipeline surface from corrosion due to the mastic-polymer layer, unlike other thermal insulation materials;

prevents the occurrence of the "dew point" phenomenon on the pipeline surface;

it is applied in a cold way due to the self-adhesive properties of the material;

it has a uniform thickness;

it has an aesthetic appearance;

service life of 20 years;

allows you to perform sanitary treatment of an isolated surface (washing).

Protection against condensation by the technology of LLC "Sealing MaterialsPlant" is quite simple and does not require professional skills. If necessary, the pipe is wiped from moisture, cleaned of grease and dirt, then a layer of mastic is applied. Next, Abris S-LT tape, reinforced with foil insulation, is wound joint to joint, the protective film is previously removed from its adhesive layer. The seams should be closed with Abris S-LTm tape, as well as having previously removed the anti-adhesive layer from it.