RuSealing Materials Plant
Manufacturer of materials and technologies Abris.
Application of Abris hot melt adhesive
Product form
Hot melt glue Abris-rod (10-20 mm in diameter) - thermoplastic material in the form of 50 cm segments, coated on both sides with an anti-adhesive coating;
Hot melt adhesive Abris-LB (2-100 mm wide, 1.0-5.0 mm thick, 3.0-12.0 m long) is a thermoplastic roll material coated on both sides with an anti-adhesive coating.
Material description
Abris hot melt adhesive is a thermoplastic composition based on a copolymer of ethylene with vinyl acetate (EVA), synthetic rubber, powdered fillers and technological additives. Abris hot melt adhesive is produced in the form of products: tapes (LB), rods.
Construction diagram
Advantages
- manufacturability of work using the Abris adhesive layer;
- high bond strength with aluminum, polyethylene, lead, polyvinyl chloride;
- increased elastic properties of hot melt adhesive in the form of a tape;
- the joint, sealed with Abris hot melt glue, is resistant to the effects of groundwater, weak acid solutions, thermal shocks, and weathering.
Specifications
| № | Indicator | Hot melt adhesive Abris |
| 1 | Appearance | Thermoplastic uniform mass. Breaks and through holes are not allowed in the article. |
| 2 | Color | Beige to gray |
| 3 | Softening point, °С | 75-100 |
| 4 | Specific volumetric electrical resistance, Ohm • m, not less | 1•1014 |
| 5 | Electric strength at a frequency of 50 Hz, kV / mm, not less | 40 |
| 6 | Peel bond strength: -with aluminum; N / m, not less | 1000 |
| 7 | Elongation at break,%, not less | 300 |
| 8 | Water absorption,%, no more | 0,1 |
| 9 | Frost resistance (flexibility on rod), ° С | -40 |
| 10 | Density, g / cm3 | 1,36 |
Materials used:
Hot melt glue Abris-LB
Section: Tapes Packaging: corrugated cardboard boxes
TU: 2242-011-52471462-2009
Sealant in the form of self-adhesive tape, which is covered on both sides with anti-adhesive material
Ask your question
All fields marked with an asterisk (*) are required